cam selection
Quote from JPrice618 on April 27, 2019, 11:55 amLooking at cam selection on start up page 1-4 I am running this on a 1.6 roller rocker , this is advertised specs for a 1.5 so total would be 602/618 IIRC Howards roller cam
Duration 300/306, Lift .562/.580. lobe sep 110 adv dur 300 int 306 exh
Intake Duration at 050 inch Lift: 247
Exhaust Duration at 050 inch Lift: 253
Thanks Jimmy
Looking at cam selection on start up page 1-4 I am running this on a 1.6 roller rocker , this is advertised specs for a 1.5 so total would be 602/618 IIRC Howards roller cam
Duration 300/306, Lift .562/.580. lobe sep 110 adv dur 300 int 306 exh
Intake Duration at 050 inch Lift: 247
Exhaust Duration at 050 inch Lift: 253
Thanks Jimmy
Quote from Deleted user on April 27, 2019, 2:53 pmYour cubic inch would help decide, but would start with cam 3. Then want to see a datalog showing the vacuum, AFR trim and AFR learn.
Your cubic inch would help decide, but would start with cam 3. Then want to see a datalog showing the vacuum, AFR trim and AFR learn.
Quote from kjbell on May 2, 2019, 12:18 pmI have a similiar question I am getting ready to install fitech on my 400 sbc .30 over with a herbert cam 570/570,240/240,110lc which cam setting should i start with 3 or 4? thanks
I have a similiar question I am getting ready to install fitech on my 400 sbc .30 over with a herbert cam 570/570,240/240,110lc which cam setting should i start with 3 or 4? thanks
Quote from Deleted user on May 2, 2019, 1:53 pmQuote from kjbell on May 2, 2019, 12:18 pmI have a similiar question I am getting ready to install fitech on my 400 sbc .30 over with a herbert cam 570/570,240/240,110lc which cam setting should i start with 3 or 4? thanks
Probably 2 on that cubic inch. Try and look at data. Won't be 4....
Quote from kjbell on May 2, 2019, 12:18 pmI have a similiar question I am getting ready to install fitech on my 400 sbc .30 over with a herbert cam 570/570,240/240,110lc which cam setting should i start with 3 or 4? thanks
Probably 2 on that cubic inch. Try and look at data. Won't be 4....
Quote from kjbell on May 3, 2019, 11:15 amThanks for the info I will be installing in the next few weeks I’m sure I’ll have some more questions thanks again
Thanks for the info I will be installing in the next few weeks I’m sure I’ll have some more questions thanks again