Forum Navigation
Post History: Dubvalman
Hello Neil,
Thank you so much for the offer, however, as mentioned in an earlier reply I fitted …In: FITECH 39001 low idle cannot adjust up
5 years ago
I have close to a hundred miles on it now with the new unit (not a Fitech), and it drives really rea …In: FITECH 39001 low idle cannot adjust up
5 years ago
As I first suspected it is a faulty unit. I have been offered a replacement or a refund.
I strugg …In: FITECH 39001 low idle cannot adjust up
5 years ago
I wanted to try and attain I formation to correct a malfunctioning system. I have used information f …In: FITECH 39001 low idle cannot adjust up
5 years ago
Stripped out the wiring with the intentions of installing as per the plan. Once I had it all I out I …In: FITECH 39001 low idle cannot adjust up
5 years ago
I suppose that's one of the draw backs of living in a more Northerly latitude during winter 😕
…In: FITECH 39001 low idle cannot adjust up
5 years ago
Will do - I go to work in the dark and come home in the dark at the moment, so may be weekend befor …In: FITECH 39001 low idle cannot adjust up
5 years ago
Hi Austin,
So below – sorry it’s a bit long.
First – just giving a different perspective on yo …In: FITECH 39001 low idle cannot adjust up
5 years ago
Hi Austin,
Do you think it would be worth while to wrap the original Loom in EMI shielding tape?
…In: FITECH 39001 low idle cannot adjust up
5 years ago
Any suggestions what may be causing it now?
The blue wire has been shieled from just before the …In: FITECH 39001 low idle cannot adjust up
5 years ago
EPIC FAIL!
Twenty minutes or so into the drive and the same BS starts. RPM wont come back to idle …In: FITECH 39001 low idle cannot adjust up
5 years ago
Fitted the shielding on the tach (blue) wire. Soldered an earth to the shielding and earthed it thro …In: FITECH 39001 low idle cannot adjust up
5 years ago
Hi, not sure what you mean about the Delco temperature sensor. The issue is what is in the data log …In: FITECH 39001 low idle cannot adjust up
5 years ago
Hi Austin
Thanks for the patience with this. I have a battery cable connected to the cylinder hea …In: FITECH 39001 low idle cannot adjust up
5 years ago
Hi, thanks for the comment. I have 16 - 17" of vacuum. The thing just will not lean out and run …In: FITECH 39001 low idle cannot adjust up
5 years ago
Hi, just back from approximately 150 km drive - self learning, my unit must have a learning dificult …In: FITECH 39001 low idle cannot adjust up
5 years ago
Thanks for the tip. I ended up adding 20. The idle does come back better, but the last bit is still …In: FITECH 39001 low idle cannot adjust up
5 years ago