Forum Navigation
Post History: ljrios78
I had similar hot start issues and found that the system was loosing pressure when the key was off. …In: Fueling issue new install
2 years ago
Here is an update: I did not like the way the plus voltage wires were connected so I bought another …In: Ultimate LS ECU Main Cable Connector
2 years ago
Does anyone else have this jumper wire between the 2 Red Power wires on the back of their Fuse Box?
…In: Fuse Box Question
3 years ago
Here is an update:
Replaced both Relays just to be safe and reconnected the ECU. Now the ECU has …In: Ultimate LS ECU Main Cable Connector
3 years ago
Removed harness to test the pins recommended by FiTech.
Pins 3 and 28 have continuity so the grou …In: Ultimate LS ECU Main Cable Connector
3 years ago
Thanks Paul.
Still going through the list of things to check from FiTech Support and wired connec …In: Ultimate LS ECU Main Cable Connector
3 years ago
I am considering replacing my FiTech ECU since the ECU appears to be dead. I autocross the car only …In: Ultimate LS ECU Main Cable Connector
3 years ago
After several sessions attempting to start the motor failed I decided to pull to motor out again. Th …In: No Spark at 2 coils
4 years ago
The timing chain set has 8 different key ways on the crank gear to advance or retard the cam. It cam …In: No Spark at 2 coils
4 years ago
Well Fitech finally tested my ECU after it sat at their place for 3 weeks and it was fine. After a l …In: No Spark at 2 coils
4 years ago
The throttle body is anodized and there is no bare aluminum area near any of the bolts that hold it …In: No Spark at 2 coils
4 years ago
After fixing the injector vacuum leak and tightening up the header collectors the system is leak fre …In: No Spark at 2 coils
4 years ago
Ran first smoke test and found that all theleft side injectors have a leak at their base. The inject …In: No Spark at 2 coils
4 years ago
I built mine with an old canning jar, used a cotton sock for the wick and baby oil for the fuel. Use …In: No Spark at 2 coils
4 years ago
I started building a simple smoke test machine to test the exhaust system. I didn't know that a …In: No Spark at 2 coils
4 years ago
Decided to replace the coil wires with MSD wires since they have the lowest resistance on most wires …In: No Spark at 2 coils
4 years ago