Certain Options Wont Save
Just got a new Fitech Go street 400 and got it installed on my 360 v8. Got it all installed correctly, but when I got to the computer part of it everything is normal and saving correctly except for one part. the cylinders in initial set up are stuck at 144. i try to save it as 8 and send it to ecu, but whenever I reload the page or read from ECU it just goes back to 144, no matter what I do. Everything else saves normally except for that one option. Also, i tried loading set profiles for the v8, and it still stays at 144, no matter the profile i load.
Calibration Lock is enabled
Go to main menu>display setup>Calibration Unlock
Switch it from disabled to enabled
If that doesn't work then try ecu programmer or updating the software.
.
I have heard about that, i tried both enabled and disabled to see if anything would happen, and of course with my luck nothing changed. is there a way i can download that software or would i have to contact fitech in order to get it?
Best way is to contact Fitech.
You can try ecu programmer if you have a new style "2 dot" handheld.
go do dislpay setup to enable ecu programmer
then on main menu select ecu programmer.
let it finish
then write cal to ecu
then initial setup and send each to ecu.
Had similar issue. I was told my Fitech 2 weeks ago to save every parameter one-at-a-time.