cold start idle hunting
Quote from taylorteamracing on January 6, 2019, 11:57 amto start the 545 871 blown big block I have to cycle the key 3 time with throttle crack to get fuel down in the intake I start the car with the timing control retarted and once it starts the idle surges for about 45 seconds and then goes steady and once you get warm it just starts fine and idles
to start the 545 871 blown big block I have to cycle the key 3 time with throttle crack to get fuel down in the intake I start the car with the timing control retarted and once it starts the idle surges for about 45 seconds and then goes steady and once you get warm it just starts fine and idles
Quote from Deleted user on January 6, 2019, 12:17 pmCould it be a lean surge?
Could it be a lean surge?
Quote from Deleted user on January 6, 2019, 12:18 pmMight try adding some to the Afterstart.
Might try adding some to the Afterstart.
Quote from taylorteamracing on January 6, 2019, 5:51 pmdon't know exactly what to change for that but I did just get back from the maiden voyage the only issue I had was a loose ground for the water pump overheated a bit but during the drive throttle response was good responsive no dead spots it was only a mile or so before the over heat but running with no issues
don't know exactly what to change for that but I did just get back from the maiden voyage the only issue I had was a loose ground for the water pump overheated a bit but during the drive throttle response was good responsive no dead spots it was only a mile or so before the over heat but running with no issues
Quote from Deleted user on January 6, 2019, 6:39 pmGood deal.
The afterstart section is within the cranking menu. It will richen the mixture for warmup.
Good deal.
The afterstart section is within the cranking menu. It will richen the mixture for warmup.