Hard starting fires then dies not white wire
Hello I have the fitech go efi 600 a 302 board 40 over with a mild cam the initial start up went OK, the engine was running pretty good for 50 miles, it is not starting now it fires up and then dies, it will barely start even with me opening The throttle a little bit, it’s initial start up for the day was very hard starting but it did start without throttle and it would idle but rough, my IAC steps at idle and Temp are fluctuating between zero and four, I have not been able to drive it to adjust them further.
I have rerouted the fuel line suspecting vapor lock issues But it is still not starting without throttle and when it does start it will not stay running Unless I force it, while I am forcing it to stay running I put it in gear and it dies, suspecting IAC steps please help.
Post a 30 second idle datalog at operating temperature.
Also
i hooked the white wire up to a separate fully charged battery on a charger I then watched the volts drop too 4v then up too 10.4- 11.3
i called fitech told them and it was unusual enough to have them tell me to send it back to get checked
it checked out nothing wrong they are sending it back should see it soon
thanks for your help
It looks like it worked, this is the only way I could figure out how to post a dialogue? Hopefully this works for you. Thanks Austin!
I didn't get your link to work. We typically use Dropbox to share the datalog. You can create a link and post on the next comment.