LS 70051
Quote from Cantinflas on March 25, 2024, 3:26 pmCant get it to hold the cam selection it wants to run at number 4 as soon as i change it back to 1 goes full rich and dies. It had run decent on cam 1 also my target afr will move to 12.80 at idle i have it set at 14.70 engine will not accelerate past 4000 rpm if falls flat on its face and goes rich. I was told cam sensor pins were wrong checked those got those in order told the Map sensor got new one still same thing got new o2 sensors same thing nothing changes the way it runs just wants to go rich. I sent in a few logs and can not get any direction on what to do. Motor is a 6.2 BTR cam 4L80E have yet to see the tcc stay fully engaged also but thats another issue for another day. May have to carb this thing i have been fighting this for 3 months now no light at the end of the tunnel yet.
Cant get it to hold the cam selection it wants to run at number 4 as soon as i change it back to 1 goes full rich and dies. It had run decent on cam 1 also my target afr will move to 12.80 at idle i have it set at 14.70 engine will not accelerate past 4000 rpm if falls flat on its face and goes rich. I was told cam sensor pins were wrong checked those got those in order told the Map sensor got new one still same thing got new o2 sensors same thing nothing changes the way it runs just wants to go rich. I sent in a few logs and can not get any direction on what to do. Motor is a 6.2 BTR cam 4L80E have yet to see the tcc stay fully engaged also but thats another issue for another day. May have to carb this thing i have been fighting this for 3 months now no light at the end of the tunnel yet.
Quote from Cantinflas on April 9, 2024, 5:35 pmGot the fuel tables ironed out runs much better still working on the timing tables but iam happy now with the results> I just had to try things myself seem to have got a handle on it about 70 percent i will keep chipping away at it. Just wanted to give you all an update.
Got the fuel tables ironed out runs much better still working on the timing tables but iam happy now with the results> I just had to try things myself seem to have got a handle on it about 70 percent i will keep chipping away at it. Just wanted to give you all an update.