My log. Bogs terribly under upon throttle and over idles when I shut off.
Quote from 66GTAconv on June 9, 2019, 12:40 amOK....here is my Log.
https://www.dropbox.com/s/ia7idmjdpjbwx1s/DashBoard7.xlsx?dl=0
It bogs HORRIBLY when I punch it also bellows smoke out the back and idles on when I shut her down.
I have clearly meddled with something I don't know much about in ProTune
Fitech 30008. MSD coil and dist set up.... no msd box
Edelbrock heads. 462 SCAT stroker. 11-1 compression
3/8 fuel line with pump
Tremec t5
The cam is an Edelbrock part # 7106: Duration @ .050 Intake: 236 degrees • Duration @ .050 Exhaust: 236 degrees • Lift @ Valve Intake: .572” • Lift @ Valve Exhaust: .572” • Lobe Separation: 108 Degrees • Intake Centerline: 103 Degrees •
Fans work GREAT....so I figured out that part LOL
OK....here is my Log.
https://www.dropbox.com/s/ia7idmjdpjbwx1s/DashBoard7.xlsx?dl=0
It bogs HORRIBLY when I punch it also bellows smoke out the back and idles on when I shut her down.
I have clearly meddled with something I don't know much about in ProTune
Fitech 30008. MSD coil and dist set up.... no msd box
Edelbrock heads. 462 SCAT stroker. 11-1 compression
3/8 fuel line with pump
Tremec t5
The cam is an Edelbrock part # 7106: Duration @ .050 Intake: 236 degrees • Duration @ .050 Exhaust: 236 degrees • Lift @ Valve Intake: .572” • Lift @ Valve Exhaust: .572” • Lobe Separation: 108 Degrees • Intake Centerline: 103 Degrees •
Fans work GREAT....so I figured out that part LOL
Uploaded files:
- You need to login to have access to uploads.
Quote from TTA Perf on June 13, 2019, 10:56 amSomething is not right with your set up.
1. Your log is not showing any learning happening. Your AFR Trim % and AFR Learn are at 0. Did you turn them off?
2. Your actual AFR never changes from 14.7 Your target AFR does change. Where is your oxygen sensor located in the exhaust?
4. How is your oxygen sensor mounted in the exhaust and is there any exhaust leaks near it?
5. Is the oxygen sensor fully plugged in?
Something is not right with your set up.
1. Your log is not showing any learning happening. Your AFR Trim % and AFR Learn are at 0. Did you turn them off?
2. Your actual AFR never changes from 14.7 Your target AFR does change. Where is your oxygen sensor located in the exhaust?
4. How is your oxygen sensor mounted in the exhaust and is there any exhaust leaks near it?
5. Is the oxygen sensor fully plugged in?