New to Forum and Fitech
You should have at least a 180 thermostat and maybe even a 190 to run efficiently.
Quote from flatbill on August 12, 2020, 8:47 amYou should have at least a 180 thermostat and maybe even a 190 to run efficiently.
It does around town but on the open highway with cool winter air its around 170-180 ish on the gauge but the fitech is way out as you recently alluded to. Its a slant 6 engine and some of them had 160 thermostats fitted from factory. I might have to pull mine out to see what its running.
Is the ACDelco 213-928 a direct replacement for the original fitech temp sensor>
Cheers
Lee
I don't know the number. Someone will let you know. Its the standard Delco gm temp sender. I'll try to find the number.
Quote from flatbill on August 12, 2020, 9:52 pmLook here.
https://fitechefituning.com/fitech-efi-tuning-forum-2/topic/temp-sensor/
because its a slant 6 i am pretty sure all the dodge guys etc have to use another sensor. I might have to try and find one
Replacement Parts
Coolant Temp Sensor
AC Delco 213-928
Recommended replacement for supplied sensor. https://amzn.to/2IEZ7L8
O2 Sensor
Bosch 17014
Direct replacement for the supplied sensor. https://amzn.to/2XrXHYF
Fuel Pressure Regulator
Bosch 3 bar 0280160557
43psi regulator for the Go Street and Mean Street units. https://amzn.to/2GmeKo9
Bosch 4 bar 0280160575
58psi regulator for all units except Go Street and Mean Street. https://amzn.to/2VVb5Ec
FPR Delete Plug
Regulator delete plug for external regulators. This will allow you capability of looping the fuel
system through the unit. https://amzn.to/2IGwNYZ
MAP Sensor
Not serviceable. Part of the ECU on the throttle body units.
Injector
Fitech only $35 each
IAC Motor
AC Delco 19333273
Recommended replacement for supplies motor. https://amzn.to/2IvzBJ0
TPS
AC Delco 213895
Recommended replacement for supplied sensor. This one has the angled plug like original.
I had to replace temp and O2 sensors, fuel pressure regulator had a damaged O ring so replaced whole unit as well.
As long as the threads are the same in your motor this sensor will work.
Quote from flatbill on August 13, 2020, 9:02 amAs long as the threads are the same in your motor this sensor will work.
FYI i got the car back and took it for a drive. There is approx 40F discrepancy between fitech and aftermarket gauge and booth sensors are within 1 inch of each other. I have ordered a replacement ACDelco.