Throttle body side harness
Hello, I have a question about the wiring on the TB side of the 6 Pin connector. I have a 600hp Go EFI 4 non power adder system that has had the wire harness cut (no 6 pin connector). I believe I have all of the wires identified except the little red wire that also has a fuse holder. There is actually 7 wires on the TB side. From every picture on the net that I can see, this little red wire does not have a corresponding pin in the connector. I have also seen where the harness has been updated to split out to a 2 pin (Fuel Pump and Main Power) and a 4 pin harness (smaller gauge wires White/Black/Blue/Yellow). The little red wire isn't in either of the connectors that I can see anywhere. Does this little red wire combine with the heavier gauge yellow main power wire on the TB side? Is it fused at 15 amps? TIA...
Anyone?
You are not referring to the "large" red wire for power supply, right? I have the 6 pin connector and the only red wire is that one. However, maybe there is a 7th wire coming out of the TB that I can't see. In the Power Adder version there is another thinner red wire, which is the A/C signal. I wonder if there for all the units, but disable unless it is a Power Adder.
https://www.jegs.com/InstallationInstructions/500/546/546-30001.pdf
No, I know the large red wire is the main power supply which actually turns into the heavier gauge Yellow wire. What I am referring to is the thin red wire that also has a in line fuse holder from pictures I have seen across the net. I do see in the instructions that the Power Adder version shows a thin red wire used for the AC, however I don't have the Power Adder version or the extra 4 wires. I think the Power Adder version has an additional 4 pin connector with the thin red (AC) Black (2nd Fan) white (nitrous in) tan (nitrous out). Here is what I have
Uploaded files:- You need to login to have access to uploads.
I have found pictures of the TB side harness that is basically the same as this picture all over. You can see the small red wire has a fuse holder. The heavy gauge yellow (main power) heavy gauge orange (fuel pump) also have in line fuse holders. I just cant identify this small red wire on a Non power adder system. Thanks for any help, I sincerely appreciate it.
Uploaded files:- You need to login to have access to uploads.
I found out on mine that the red wire and the thick yellow wire both have fuses and eventually join together into the +12v. So I have 7 wires out of the TB and 6 wires at the connector.
Thank you so much! Really appreciate it. That's what I was hoping to confirm.