Ultimate LS 70050, stalling while slowing down where engine cuts off.
I've installed Fitech 70050 on my Gen 3 fresh engine, I'm taking the car out for a drive and the engine seems to cut out when I'm slowing down before I come to a stop it cuts out. The engine will start up again but I'm concerned that I might get rear ended while having to pulling over to re-start.
It starts up fine from a cold start and runs fine, I've got the cam setting on 2, 222/224 duration .565/568" lift comp with 42 lb injectors on a LS3 intake. IAC set to 5, Holley 12-300 in tank pump with a vent on my stock tank, idle set at 750.
Any ideas what's causing the stall out?
Have a friend that wants to go into the tables remotely and see whats going on, so I want to install Procal. Do I get my handheld to install the Procal then got through this online sequence to be able to make changes?
Calling on Paul Bell or anyone else to help would be appreciated in helping me get this stall situation fixed or with loading Procal.
Simon
Having this very same issue with my FiTech 70050 on a Gen 3. Hopeful someone will post some hints. System doesn't seem to be "learning" it's way (not sure if supposed to).
Dave