Forum Navigation
Post History: stevant
All has been resolved, in fact the issue was not my Fitech but instead an intermittent ignition modu …In: Won’t start, 600
5 years ago
Ok, will do. Do I adjust the accel pump once I see what it’s doing? Is that what I need to adjust?In: Acceleration issue
5 years ago
Hi,
When I gradually increase the throttle, between 1500-2500 rpms, the engine starts to bog a li …In: Acceleration issue
5 years ago
5 years ago
I found some info after I posted this and it mentioned to lower the value on both the Dfco Cut Fuel …In: Popping during deceleration
5 years ago
Hi all,
I’m getting a slight popping on decelerations once in a while and I’d like to know where …In: Popping during deceleration
5 years ago
Take a look at this ignition module. Shouldn’t look like this. I installed a new one. RPM’s read …In: RPM is all over during engine cranking
5 years ago
Thanks Austin...... the coil is 10” from the front of the Fitech. Still can be an issue?In: RPM is all over during engine cranking
5 years ago
An additional test this morning. I disconnected my coil wire to my distributor and connected it to …In: RPM is all over during engine cranking
5 years ago
I’ll try to keep this short. I am building a Cobra, simple electrical system. Engine is grounded t …In: RPM is all over during engine cranking
5 years ago
I hope I’m not coming across as unappreciative of your insight. I’m just frustrated. I really thin …In: Won’t start, 600
5 years ago
This is a Cobra btw, my battery is grounded to the frame with 2awg, it also grounds directly to my …In: Won’t start, 600
5 years ago
I hope someone is reading this as my situation seems to worsen. My blue wire is away from the loom …In: Won’t start, 600
5 years ago
I ordered the tin shielding for my blue wire and will duplicate what Poncho did. I have a ground ba …In: Won’t start, 600
5 years ago
Gave it the college try this morning and no luck. I did get the RPM noise error code again. Car had …In: Won’t start, 600
5 years ago
Just want to wrap up my day and let you know what’s happening. I checked the coil ohms on my primar …In: Won’t start, 600
5 years ago
Just want to add that my spark is very yellow and appears dim......... usually are a silver blue col …In: Won’t start, 600
5 years ago
No error codes, getting an rpm reading at crank up. I see gas going in. Cleaned all my plugs. Sam …In: Won’t start, 600
5 years ago
I’be been running my engine since last September and all has been good, except the last few weeks. …In: Won’t start, 600
5 years ago
A friend of mine changed his Fitech sensor today with the AC Delco with the same success. His Fahre …In: Coolant Temp Sensor adjustment
5 years ago
I set my IAC’s as instructed when initially setting up my build. Engine is running nicely. When I …In: IAC’s settle in after restart
5 years ago
New replacement sensor went in today....... I’m a believer. My Fitech handheld temp now matches my …In: Coolant Temp Sensor adjustment
5 years ago