Very rich when warm
I sent both of those datalog to show engine sensors when COLD start. I can drive the car for hours COLD start. If i stop for gas or lunch the car wont run unless i let it cool down to under 130 or so. The very first datalog i sent is result of warm start and car runs so bad barely stays running at all. I really want to thankyou for your help so far but any help with warm start problem would be great. The car is currently a garage queen. And may soon be carborated again.
So far i have gotten the car to run with warm start. By setting a couple parameter changes
prime multi. Factory 259 i set 100
crank 170 chged from 0% to -70%
crank 65 chged from 0% to -60%
The run state still says crank ????
and it now idles at 1200rpm but i have set idle to 750 at least it runs smooth not super rich
it also shows target rpm 900 i think that is because of run state crank
any idea where to go from here
the crank state concerns me
the idle would fix itself i think if run state were normal
Try reloading software by using the ECU programmer. This can resolve any bugs and starts you with a clean slate.
I have no idea how to do that. Where can i get the software and how do i get an ecu programmer.
Any help will be greatly appreciated
thanks for all your help so far.
Austin; you are a life saver. The reload did it. I have made a small donation to this site and will continue to do that as often as i can. You do good work here and hope my support will help it continue to be available
Thank you!!!