will not run after initial setup
just to let you guys know I have found the problem, the discharge plastic fitting on the high pressure pump was broke right off so the pump was just pumping inside the tank. Pretty frustrating when you buy a brand new system and have 2 problems the first I never told you guys was the handheld controller had to be replaced (warranty) when it gave me an error of CANT FIND WORK GROUP CHECK TF CARD when I went to the Go-EFI initial setup. I would like to thank you guys for the help and I'm sure I will have more questions once I get a new pump and get it up and running, thanks again
Blaine
hi
well I got the new pump for the G-Surge tank and got everything setup and got the truck running and had it out a couple of times a couple of miles the first time and came back to garage just to check everything and then about 1 hour later went out again and put about 10 miles on it and got back to the garage and was sitting in the garage with it idling and was setting up the large dashboard and had 4 things setup and then tried to put a 5th thing on the dashboard and as soon as I hit enter the truck shut off and the screen read can only put 4 things on the large dashboard so went back in and turned off all things on the dashboard and now the truck wont run, it was a good thing I was sitting in the garage after the 10 mile drive. is this just a coincidence with setting up the large dashboard? I let the truck cool down and tried starting again but all it will do is crank and wont fire and run, I tried opening the throttle a little but still wont run, have the proper voltage when cranking and the controller shows RPM, any suggestions?
Blaine
I have had to reset the ecu and do a initial set up again and have adjusted throttle screw and got the IAC steps down between 3 to 10 I will take it for a drive later and report back
Blaine
That is odd. Glad you got it going again.