Forum Navigation
Post History: jkhall316
Set your rev limit above your shift point. This fixed it for me.
Example: …In: tranny not shifting at WOT
7 years ago
I have a 1970 RS Camaro.
My gauges are Dakota Digital VHX. Speedo and Tach work perf …In: Here is what I have learned so far with my 70004 FiTech
7 years ago
Things I have learned with the FiTech Ultimate LS 70004 KIT
1. The tech support with FiTech …In: Here is what I have learned so far with my 70004 FiTech
7 years ago
7 years ago
found the reason AFR Pas Trim% was negative ...
My header is leaking where I bottomed out the car …In: check my logs please.. low power..
7 years ago
https://www.dropbox.com/s/6f5ufoa2uj26m1y/Basic%20Sensors2.csv?dl=0
In: check my logs please.. low power..
7 years ago
I have it up and running again... just configured my ECU.
Does not seem as strong as it …In: check my logs please.. low power..
7 years ago
it would just power down... I called tech support and Bryan helped me. Just reset the system ag …In: run a few seconds and then shut off
7 years ago
confusing problem just happened.
I jumped in the Camaro with the 70004 Ultimate LS inst …In: run a few seconds and then shut off
7 years ago
I found my issue. in basic setup/transmission/04 field I had other.. when I switched it to 4Lx0e …In: Trans line pressure and shift points
7 years ago
lo54ls I had the same issue. mine was set to other... as soon as I changed it to 4L0xe it all work …In: 4L60e not shifting out of 1st
7 years ago
I am now to this point with mine LS2 with 4L60e I have 3.73 rear gear in my camaro. NO clue what …In: Trans line pressure and shift points
7 years ago
ok.. I have the car up and running but need to get the settings in the fitech done now. for instan …In: installing FiTech Ultimate LS 750HP in my 1970 RS Camaro
7 years ago
ok. I have it together.. do the initial setup.. 364ci, 54lb injectors stage 3 cam, 24x, etc..
…In: installing FiTech Ultimate LS 750HP in my 1970 RS Camaro
7 years ago