Forum Navigation
Post History: plumbpiper
Would it be better to run a boost reference to regulator above the TBI ? My pressure isn't goi …In: Boost reference to regulator
5 years ago
I ran a stainless line out to a guage that I can see while driving. Everything goes at the same time …In: Electrical Gremlin
5 years ago
Dedicated ground didn't work. I am wondering if my MSD 6AL-2 is dying after it warms up. Might …In: Electrical Gremlin
5 years ago
5 years ago
Got my ride painted up and ready to do some cruising and track time. Problem is it runs just fine fo …In: Electrical Gremlin
5 years ago
IT'S ALIVE. After the lifter and push rod change it fired right up on the first try. I am a hap …In: No initial start.
5 years ago
Very cool. If I do another build I plan on an aftermarket 351W block to do a small block 427. Lookin …In: No initial start.
5 years ago
That's some healthy lift. I installed .565/.565 lift, but went long duration, reverse for turbo …In: No initial start.
5 years ago
That was what made me suspect the lifters. Comp was bleeding fast. Also I should have suspected the …In: No initial start.
5 years ago
IT'S NOT THE FITECH. Kinda upset at whoever filled out my roller lifter order. I ordered HYDRAU …In: No initial start.
5 years ago
Thanks Ajax
Plugs seem fine and I have done the timing light on several plugs. Working on getting …In: No initial start.
5 years ago
Merry Christmas and thanks for your input. Out of all the suggestions the only thing I haven"t …In: No initial start.
5 years ago
The tach signal comes from the MSD box when using timing control. Do I need to open up the 6 wire ha …In: No initial start.
5 years ago
Thanks for the response.Already checked that. The voltage does jump a bit while cranking, but I neve …In: No initial start.
5 years ago