Forum Navigation
Post History: 91jeep
Looking at my logs, My AFR numbers look good. Not jumping around, and steady. But the AFR Trim num …In: AFR Settngs
7 years ago
Can some one give me the definition of Idle Stbl that is listed in the ignition control logs. My lo …In: Definition of Idle Stbl
7 years ago
I am working on the timing issue and want folks to look at the last log file and if you can, tell me …In: Look at log file
7 years ago
7 years ago
I have a 1999 Corvette LS1 stroked to 383 running in a 1991 Jeep Wrangler. I cannot get it to stay …In: Timing Examples
7 years ago
7 years ago
I just went and checked, and field 5 is set the way you indicated. 4L6xe.
But field 4 only has 2 …In: Need VSS help
7 years ago
Still do not have speed signal to controller. This is a 4 wheel drive jeep, and the Atlas transfer …In: Need VSS help
7 years ago
I installed the LS Ultimate system recently and finally got it out on the road for a shake down driv …In: Need VSS help
7 years ago
I know, that is what all the information I have found says, "It can be adjusted". Just lo …In: Tach Output
7 years ago
I am trying to get my Autometer dash tach to read correctly. I have the 70004 Ultimate kit installe …In: Tach Output
7 years ago
Yes, and read it at lest 50 times. It is very lacking. The only thing is says is put this part her …In: Need Startup Help
7 years ago
Today's Update
Last night, I screwed the idle screw in about 3 turns and it cranked up and i …In: Need Startup Help
7 years ago
7 years ago
That's my point, the flow chart would be an evolving document as people have different issues a …In: Need Startup Help
7 years ago
Well it time for another update.
I screwed the throttle limit screw in about 3 turns and it crank …In: Need Startup Help
7 years ago
OK, The daily update.
Replaced the Cam sensor and it sounds like it wants to run more than it did …In: Need Startup Help
7 years ago
Can someone verify I have the correct coil packs. I started this build with a bare block, so want t …In: Need Startup Help
7 years ago
I agree it is a timing issue. Don't think it could be a wrong firing order because to my knowle …In: Need Startup Help
7 years ago
Just finished putting it all back together after checking the timing chains marks. Tired to crank i …In: Need Startup Help
7 years ago
If I had any fault codes, that might help in the trouble shooting. But mine is clean, no codes.In: Need Startup Help
7 years ago
I checked, yes. But i would think if it was a blown fuse, I would not get any spark. It spits and …In: Need Startup Help
7 years ago
Yes, verified that. As I said, I ohm'ed out each individual coil wire from the ECU connector a …In: Need Startup Help
7 years ago