Forum Navigation
Post History: Crankyolman
I'm kind of saddened by the fact that this post has been here 3 weeks and nobody bothered to ev …In: Won't stay running, data log included
6 years ago
The short version of the story is my truck sat for the better part of 3 months while being repainted …In: Won't stay running, data log included
6 years ago
I had a similar issue. It turned out that the electrical connector to the fuel pump didn't clic …In: Injector issue?
6 years ago
Quote from sonoraed on August 3, 2019, 4:34 pm
The Tri Power TBI's were really made to fit a M …In: new Tripower install
7 years ago
Sonoraed, can you tell me what the bolt spacing is on the base of the tri-power throttle bodies? I h …In: new Tripower install
7 years ago
Nice, I'd rather have a flask too.
On the lean issue, what is your fuel pump? Are you using …In: Running rich off of idle
7 years ago
7 years ago
I see your IAC steps are very high but I think that is a problem mostly at idle but it's someth …In: Running rich off of idle
7 years ago
I know I've mentioned vacuum before but I have to ask, do you know if your vacuum is reading in …In: Running rich off of idle
7 years ago
If your using the fitech sensor replace it with a Delco one. I have a 180 thermostat and my Fitech o …In: What Temp Thermostat
7 years ago
Those wires that look bad aren't even hooked up, they are old wires I just haven't bothere …In: 72 Jeep truck with 2BBL
7 years ago
Quote from Austin DeHaas on June 8, 2019, 2:13 pm
We need to work on some of that wiring brother... …In: 72 Jeep truck with 2BBL
7 years ago
Not sure this is the right place to post this but yesterday I began working on duel snorkel air clea …In: 72 Jeep truck with 2BBL
7 years ago
Quote from Austin DeHaas on June 4, 2019, 8:44 am
Quote from Crankyolman on June 3, 2019, 3:53 pm …In: Running rich off of idle
7 years ago
Thank you Austin,
I've been slowly adjusting cranking settings. Warm it starts fine but cold …In: What's next
7 years ago
Thank you ATT Perf,
My truck runs real well with no issues at all, in fact I'm still getting …In: What's next
7 years ago
I admit I know absolutely nothing about this stuff but I've been told that proper voltage is cr …In: Running rich off of idle
7 years ago
Thank you ATT Perf,
Here is today's log.
https://1drv.ms/x/s!AtllmUWFvoeUgisowM08fzhrIWuL …In: What's next
7 years ago
Quote from TTA Perf on May 31, 2019, 12:11 am
The log looks great to me.
When I look at an idle …In: What's next
7 years ago
I got my fuel pressure gauge the other day, I took it to my work and had our people who certify inst …In: What's next
7 years ago
Got a gauge and fitting ordered. I'll let you know when I get some more info on fuel pressure.
…In: What's next
7 years ago
I finally got the IAC step down. It's around 8 ish although it did drop to zero for a bit. The …In: What's next
7 years ago
Thank you TTA Perf
It took a lot of adjusting but I got the IAC count down to around 18. Here is …In: What's next
7 years ago
It was in park and all settings are as it came out of the box.
What should AIC steps be? Is that …In: What's next
7 years ago
Ok I have now had my FI up and running for 2 weeks and around 140 miles in various conditions. Hopef …In: What's next
7 years ago
I did the all of that and it runs fine, I also read all the definitions a couple times over. I guess …In: Confused about initial setup
7 years ago
A few days ago I installed a Go EFI 2 barrel on my truck. I was a little confused about the initial …In: Confused about initial setup
7 years ago