Forum Navigation
Post History: mkm492
It runs great, no issues. Plugs look good, I think. Picture is 0f #1 and #4. 4 seems a little richer …In: AFR goes rich intermittently during cruise
5 years ago
Sorry, I usually get this one right.
https://www.dropbox.com/s/y2ix7jzkhb3w60d/Log%20DB%2082%20Ex …In: AFR goes rich intermittently during cruise
5 years ago
Are 80 lines enough, or should I send more? I think this shows how it goes rich at cruise.
https: …In: AFR goes rich intermittently during cruise
5 years ago
Hey Austin, been traveling for work last couple months. Car runs great, seems to have learned all it …In: AFR goes rich intermittently during cruise
5 years ago
Thanks Austin. I'm like a nervous parent. Once I get this right I'm going to post a step b …In: AFR goes rich intermittently during cruise
5 years ago
Starting a new thread cause its been a few months and my first one got hijacked. 427w dual quad fite …In: AFR goes rich intermittently during cruise
5 years ago
FINALLY! I got the fronts (#s 1,2,5,6) balanced with the rears (#s 3,4,7,8.) Now all plugs are look …In: Rich on low rpm cruise
5 years ago
Spoke with FiTech again and got a completely different procedure for dialing in 2x4. Day before yest …In: Rich on low rpm cruise
5 years ago
Since I noticed the disparity front to back, Ive been checking all eight.
What exactly does the I …In: Rich on low rpm cruise
5 years ago
Front and rear plugs are still not balanced. Rears are good, but the fronts, though better, are stil …In: Rich on low rpm cruise
5 years ago
Excellent! Next time its dry and over 50F I'll get a cruise log. Thanks for all your help.In: Rich on low rpm cruise
5 years ago
https://www.dropbox.com/s/j182gewtl0f4mux/DashBoard34.csv?dl=0
Please check my new idle log.
R …In: Rich on low rpm cruise
5 years ago
Dual quads, and four barrel carburetors are new to me. Directions for 2x4 from FiTech are non-existe …In: Rich on low rpm cruise
5 years ago
Changed my Target AFRs 1100 45kPa and 3000 45kPa from 14 to 14.4. Logged a cruise and got deviating …In: Rich on low rpm cruise
5 years ago
I'm going to install a high flow 180F thermostat first. Also, do the two dizzy wires going to t …In: Rich on low rpm cruise
5 years ago
https://www.dropbox.com/s/ne21cfvf0rhwn3q/DashBoard29.csv?dl=0
Shielded Tach wire from …In: Rich on low rpm cruise
5 years ago
The tach output from the MSD 6AL (6425) appears to go to the tach, then back to the fitech harness. …In: Rich on low rpm cruise
5 years ago
Thanks Austin. From what bdhulderman said, this code would make sense. I'll clear the code befo …In: Rich on low rpm cruise
5 years ago
Thanks so much for your post! Is the ground wire part of the loomed bundle, or is supposed to come o …In: Rich on low rpm cruise
5 years ago
bdhulderman, Are you using timing control? The reason I ask is that I read that the FiTech ecu is le …In: Rich on low rpm cruise
5 years ago
If I was going to change to using timing control, should I wait till I get the fuel issues sorted be …In: Rich on low rpm cruise
5 years ago
Here is a pdf excerpt of a log at cruise. Don't understand why the actual AFR and target AFR ar …In: Rich on low rpm cruise
5 years ago
Dashboard 25 is a 30 second idle. I did lower the IAC. Dashboard 24 is a cruise and a big file. I� …In: Rich on low rpm cruise
5 years ago
https://www.dropbox.com/preview/Roadster%20logs/DashBoard25.csv?role=personalIn: Rich on low rpm cruise
5 years ago
5 years ago
Put in new plugs and set idle AFR target to 14.2 (up from 13.5.) Idled for 15 minutes after warmup. …In: Rich on low rpm cruise
5 years ago
Ok, my plan is to raise my idle AFR target in increments of .5 and also thinking of trying non resis …In: Rich on low rpm cruise
5 years ago
bdhulderman, The motor is fresh with only about 1.5 hours on it since first start. I hold it at 2k r …In: Rich on low rpm cruise
5 years ago
The plugs were showing rich, but not wet before. First log since moving o2 sensor. I'll be chan …In: Rich on low rpm cruise
5 years ago
https://www.dropbox.com/s/e6goflj4ut3w1kt/DashBoard22.csv?dl=0
Moved the o2 sensor to a …In: Rich on low rpm cruise
5 years ago
The FiTech CTS was bad, never reading above 136F. It was replaced and reads consistent with dash gau …In: Rich on low rpm cruise
5 years ago
Thanks for the reply. 427W with 30062 2x4. MSD dizzy and box. I'm not using FiTech timing contr …In: Rich on low rpm cruise
6 years ago