Forum Navigation
Post History: mark_j@windowslive.com
Hi Ben
The Fitech tech help line insist it is either an exhaust leak or a fuel pressure issue.
…In: 025 sensor
7 years ago
Hi Austin
Unplugging the O2 sensor was the first thing I did, right before I replaced it.
Neit …In: 025 sensor
7 years ago
By the way I am using a 40015 in tank pump.
I have used a relay close to the pump like the pump i …In: 025 sensor
7 years ago
Hi Austin
I got this answer from Fitech:
The log shows the system is doing its job but I am co …In: 025 sensor
7 years ago
7 years ago
Hi Austin
I thought I had already posted this but cant see it. May have deleted it by mistake.
P …In: 025 sensor
7 years ago
Yes I reset to a base tune and no difference, so reloaded my saved tune.
Ill update the software …In: 025 sensor
7 years ago
Hi Austin,
Ive sent it from my partners work email (m.kan@barfoot.co.nz) to your hiway dreams acc …In: 025 sensor
7 years ago
Yes have a full exhaust. The frustrating thing is we got the car running great about a month ago and …In: 025 sensor
7 years ago
I also leaned out the AFR targets on the hand held but it didn't respond, turned it off and res …In: 025 sensor
7 years ago
Hi Austin
I went for a drive and it was running as it should. after about 45 min I was in a line …In: 025 sensor
7 years ago
7 years ago
Hi
The problem was a faulty regulator. Now its charging at 14+ volts it seems to be running fine. …In: FITECH 39001 low idle cannot adjust up
7 years ago
Hi
I have been watching this conversation with interest as I have very similar issues.
The car …In: FITECH 39001 low idle cannot adjust up
7 years ago
Merry Christmas to you all.
We did a big cruse today , about 3 hours of driving.
It was very g …In: Rich on low rpm cruise
7 years ago
Thanks for the advice, tuning to vacuumed worked great. It’s now starting and idling the best it has …In: Rich on low rpm cruise
7 years ago
well, if all else fails read the instructions. Ones I replace the blower 20a fuse with a 40a it all …In: Fan not switching
7 years ago
Hi
Used the jumper between pin 85 and battery neg.
Could here the relay clicking but …In: Fan not switching
7 years ago
Thanks....Just to confirm.
85 will have both the yellow and the earth to battery on it??
  …In: Fan not switching
7 years ago
I have just fitted an frtermarket electrical fan. If I run the fan straight to the battery it works, …In: Fan not switching
7 years ago
Hi All
I have just fitted a 2 barrel fitech to a 62 Mercury Monterey 352FE.
With Austins help …In: Rich on low rpm cruise
7 years ago
7 years ago
7 years ago
Hi Austin
I turned the idel screw 1/4 turn clockwise and disconnected the throttle linkage. When …In: Tach Signal missing
7 years ago
Hi Austin
Link for datalog.
https://www.dropbox.com/s/aiienw0n8vlkrtk/Basic%20Sensor …In: Tach Signal missing
7 years ago
Hi Austin
After The TPS moves to 0.5 i shut it down.
When I restart the TPS still reads 0.5 be …In: Tach Signal missing
7 years ago
Thanks for the advice, once the Fitech got 12V during cranking it starts great.
I cant get the IA …In: Tach Signal missing
7 years ago
I got a response to my question within 12 hours from this site. After 6 days waiting for an email re …In: Tach Signal missing
7 years ago
7 years ago
